Interrupteur d'éclairage avec détecteur de mouvement

This product is an energy automatic sensor switch, it can identify day and night. It adopts an infrared detector, IC, and SMD technology, when someone enters its detecting range and triggers it works, the infrared detector turns on the lamp, and after it leaves its range, the lamp will turn off automatically. It can detect the ambient light illumination automatically and set and adjust the value according to the fact needs. Such as the light will turn on and work when the ambient light illumination is under setting value. once it exceeds the setting value, the light will stop working. It can be installed indoors, in corridors, and in public buildings.

Caractéristiques techniques

Power source : 220-240V / AC , 50HZ

Rated load:

500W Max tungsten ( 220-240V / AC)

150W Max fluorescent ( 220-240v / AC)

Time setting: 5s, 30s, 1min. 3 Min, 5 Min, 8 Min( adjustable )

Light-control: < 10lux-2000lux ( adjustable)

Working temperature : -10- + 40 C

Detection range: 8m ( 22 " C ) ( adjustable )

Working humidity: <93 % RH

Detection angle: 100

Fonction

1 . Adopts 8-bit DIP switch: You can select working light to work only in the light below 10lux or in any light; Adjustable sensitivity; Choose the working time-delay of the load: 5s, 30s, 1min, 3min, 5min. 8min

2 . The time that the load work can delay automatically: it re-computes time after the last sensing.

3 . Out-connect infrared detector and sensitization resistor.

4 . Simple structure and using convenient

ATTENTION :

When use this product, please adjust the sensitivity to the appropriate position you need , please do not adjust the sensitivity to maximum, to avoid the product does not work normally caused by wrong motion. Because the sensitivity is too high easily detects the wrong motion by wind blowing leaves curtains, small animals, and the wrong motion by interference of power grid electrical equipment. All those lead the product does not work normally! When the product does not work normally, please try to lower the sensitivity appropriately and then test it